Mercury 200 OptiMax Jet Drive Service Manual page 376

Tube Ref No.
Loctite 271 Threadlocker
7
Description
Stator/wear ring mounting screws (M10 x 150) (4)
7. Remove the stator fill/drain and vent plugs. Apply Loctite 567 PST Pipe Sealant to the plug threads.
8. Fill the stator with High Performance Gear Lubricant until oil flows out the vent hole. Install the vent plug and fill plug.
NOTE: The stator oil should be checked periodically for contamination and fluid level. To check stator oil, shift the reverse
gate to the forward position. Using an allen socket and extension, remove the stator vent plug. Use a small screwdriver to dip
into the oil to check it for contamination, discoloration, and level. If oil is low, add oil. If oil is contaminated or discolored, shaft,
seals, and bushings must be inspected and/or replaced before refilling stator with new oil. After filling the stator with oil, apply
Loctite 567 PST Pipe Sealant to the plug threads and install the plug.
a
b
c
a
Tube Ref No.
High Performance Gear
87
Lubricant
Loctite 567 PST Pipe
9
Sealant
Stator
Fluid capacity
9. Apply Loctite 242 Threadlocker to the screws securing the trim plate to the ride plate. Tighten the screws to the specified
torque.
90-8M0050731 MAY 2011
Description
Description
a
Where Used
Stator/wear ring mounting screws
a - Screw (M10 x 150)
b - Vent plug
c - Fill/drain plug
45658
Where Used
Stator
Stator fill/drain and vent plugs
b
c
45659
Nm lb‑in.
47
92-858064K01
550 ml (19 fl oz)
a - Screws (M6 x 20) (2) (30 Torx)
b - Ride plate
c - Trim plate
Pump Unit
Part No.
92-809819
lb‑ft
35
Part No.
92-809822
Page 5A-27