Mercury 200 OptiMax Jet Drive Service Manual page 133

Charging and Starting System
5. Remove the screw securing the pulley to the belt tensioner.
a
Installation
1. Install the pulley to the belt tensioner and secure with a M10 x 35 screw. Tighten the screw to the specified torque.
2. Lubricate the belt tensioner bushing with 2‑4‑C with Teflon. Install the bushing into the belt tensioner.
3. Replace the grease fitting if damaged or corroded.
a
Description
Screw (M10 x 35)
Tube Ref No.
2-4-C with Teflon
95
4. Lubricate the washer with 2‑4‑C with Teflon and install onto the belt tensioner stud.
NOTE: Lubricate the belt tensioner spring contact surfaces on the tensioner arm with 2‑4‑C with Teflon. The grease fitting on
the tensioner assembly does not apply lubricant to this area.
5. Install the belt tensioner spring. Verify the end of the spring is in the aft facing slot on the cylinder block.
a
Page 2B-22
c
c
Description
a -
b -
b
32083
b
a - Bushing
b - Screw securing the pulley
c - Grease fitting
32079
b
a - Bushing
b - Screw securing the pulley
c - Grease fitting
32079
Where Used
Belt tensioner
Washer
End of the spring facing aft
Nm lb‑in.
34
Part No.
92-802859A 1
90-8M0050731 MAY 2011
lb‑ft
25