Mercury 200 OptiMax Jet Drive Service Manual page 331

Powerhead
7. Install a washer and nut onto each stud and tighten the nut to the specified torque.
a
Description
Nut securing air compressor
8. Tighten the two top screws (M10 x 25) securing the air compressor assembly to the cylinder block to the specified torque.
Description
Screw (M10 x 25) (2)
9. Secure the air compressor hose to the air compressor with a J‑clamp and cable tie. Secure the water hose and air compressor
hose to the air compressor with a cable tie.
a
b
10. Install two O‑rings onto the fuel rail air compressor hose fitting. Lubricate the O‑rings with 2‑cycle Premium Outboard Oil.
Page 4A-66
c
b
e
d
First
Final
c
c
a -
b -
c -
d -
e -
45931
d
45930
Water hose to expansion chamber
Nut and washer (M8)
Air compressor oil inlet hose
Oil hose to top main bearing
Oil hose to #5 reed block
Nm lb‑in.
34
Nm lb‑in.
1.5 13
56
a - Water hose
b - Air compressor to fuel rail hose
c - Cable tie
d - Plastic J‑clamp
90-8M0050731 MAY 2011
lb‑ft
25
lb‑ft
41.3