Mercury 200 OptiMax Jet Drive Service Manual page 336

4. Lower powerhead onto pump unit. It may be necessary to turn flywheel (aligning crankshaft splines with driveshaft splines)
so that powerhead will be fully installed.
Lifting Eye
Tube Ref No.
Special Lubricant 101
34
5. Install eleven nuts which secure powerhead to exhaust extension plate/driveshaft housing. Tighten the nuts in three
progressive steps until the final torque specification is reached.
a
Description
M10 nuts (11)
6. Disconnect the hoist from lifting eye and remove the lifting eye from flywheel.
7. Install the plastic cap into the center of the flywheel cover.
8. Connect the positive battery cable to the starter solenoid.
9. Connect the negative battery cable to the lower front starter mounting bolt.
10. Connect the remote oil tank pressure hose.
90-8M0050731 MAY 2011
Description
45537
91‑ 90455 1
Where Used
Driveshaft splines
a - M10 nuts (11)
a
45536
Final
Powerhead
Part No.
92-802865Q02
Nm lb‑in.
47
Page 4A-71
lb‑ft
35