Mercury 200 OptiMax Jet Drive Service Manual page 240

Tube Ref No.
Loctite 271 Threadlocker
7
Description
Screw (carbon steel) (M6 x 20)
Screw (stainless steel) (M6 x 20)
10. Install the two check valves onto the air compressor.
11. Install and secure the two J‑clamps, if used, to the air compressor with a bolt and nut. Tighten the bolt and nut securely.
NOTE: Later models will use either a plastic clip or cable ties in place of the two J‑clamps.
b
a
12. Install the O‑rings onto the reed plate assembly.
13. Install the reed plate assembly with the five petal side towards the piston.
a
14. Install the air compressor cylinder head and secure with four M8 x 35 screws. Tighten the screws to the specified torque.
15. Install the air compressor temperature sensor into the cylinder head.
90-8M0050731 MAY 2011
Description
c
a - Bolt and nut securing the two J‑clamps
b - Oil supply fitting
c - Check valves (2)
33148
b
a -
b -
36990
Where Used
Air compressor end cap screw threads
Reed plate
O‑rings
Direct Fuel Injection
Part No.
92-809819
Nm lb‑in.
17 150
11.5 100
Page 3B-77
lb‑ft