Electrical Plate And Harness Installation - Mercury 200 OptiMax Jet Drive Service Manual

Powerhead
14. Use a 3/8 in. square drive on the belt tension arm and install the belt to the air compressor pulley.

Electrical Plate and Harness Installation

1. Install the electrical harness assembly onto the engine.
2. Connect the low oil sensor bullet connectors.
3. Install the sense lead onto the alternator.
4. Connect the TPS harness connection.
5. Install the output lead onto the alternator.
a
b
a - Alternator output lead
b - TPS harness connection
c - Alternator sense lead
d - Low oil sensor bullet connectors
6. Install the nut and screw securing the electrical plate.
Page 4A-68
a
c
a - Belt tensioner
b - 3/8 in. square drive
b
45924
d
45547
90-8M0050731 MAY 2011