Mercury 200 OptiMax Jet Drive Service Manual page 290

7. Remove two nuts securing the aft portion of the electrical plate.
8. Disconnect the water pressure sensor harness and sensor retainer.
9. Disconnect the crankshaft position sensor connector.
10. Disconnect the air temperature sensor connector.
11. Disconnect the MAP sensor connector.
12. Disconnect the yellow/red lead from the starter solenoid.
13. Disconnect the harness ground lead below the starter motor.
d
14. Disconnect the oil pump connector.
90-8M0050731 MAY 2011
a - Crankshaft position sensor connector
a
b - Water pressure sensor
c - Nut (M8)
b
c
45544
a
b
c
a - MAP sensor connector
b - Air temperature sensor connector
c - Yellow/red wire
d - Harness ground lead
45545
Powerhead
Page 4A-25