Mercury 200 OptiMax Jet Drive Service Manual page 233

Direct Fuel Injection
Tube Ref No.
2-cycle Premium
14
Outboard Oil
Description
Screws
10. Install new O‑rings onto the fuel rail air hose and fuel hose fittings.
11. Lubricate the O‑rings with oil and install onto the fuel rail.
12. Secure the fittings to the fuel rail with a retainer and two screws. Tighten the screws to the specified torque.
13. Install the compressor water inlet hose to the fuel rail and secure with a cable tie.
a
b
a - Water inlet hose to compressor
b - Fuel hose retainer
c - Screw (2)
d - Air hose
e - Air hose retainer
f - Screw (2)
Tube Ref No.
2-cycle Premium
14
Outboard Oil
Description
Screws
14. Connect the engine harness connectors to the fuel injector and direct injector connectors.
Page 3B-70
Description
c
Description
Where Used
Air hose and fuel hose fitting O-rings
f
Where Used
Air hose and fuel hose fitting O-rings
Part No.
92-858021K01
Nm lb‑in.
8 71
d
e
16087
Part No.
92-858021K01
Nm lb‑in.
8 71
90-8M0050731 MAY 2011
lb‑ft
lb‑ft