Water Bypass Hose Routing; Installing Powerhead Components; Installing Individual Engine Components - Mercury 200 OptiMax Jet Drive Service Manual

Water Bypass Hose Routing

a

Installing Powerhead Components

Installing Individual Engine Components

NOTE: Engine components can be installed individually or in some cases as an assembly. If installing components individually,
refer to the following sections.
1. Refer to Section 2A - Ignition to install the following components:
• Flywheel cover
• Electronic control module
• Ignition coils
2. Refer to Section 2B - Charging and Starting System to install the following components:
• Flywheel
• Alternator
• Starter motor
• Starter solenoid
3. Refer to Section 3A - Fuel Pump to install the following components:
• Fuel lift pump
4. Refer to Section 3B - Direct Fuel Injection to install the following components:
• Air plenum
• Oil pump
• Fuel rails
90-8M0050731 MAY 2011
a - Water bypass hose to through‑the‑hull
fitting
45581
Powerhead
Page 4A-63