Air Compressor Installation - Mercury 200 OptiMax Jet Drive Service Manual

Direct Fuel Injection
16. Install the temperature sensor ground wire onto the M8 x 14 screw. Secure the temperature sensor with a retainer and the
screw.
a
Description
Screws (M8 x 35)
Screw (M8 x 14)
17. Install the air compressor pulley.
18. Apply Loctite 271 Threadlocker to the six M6 x 12 screw threads and secure the compressor pulley with the screws. Tighten
the screws to the specified torque.
Description
Screw (M6 x 12) (6)
Tube Ref No.
Loctite 271 Threadlocker
7

Air Compressor Installation

1. Install the oil line coming from the #5 reed block onto the bottom check valve and secure with a cable tie.
2. Install the oil line coming from the top main bearing onto the side check valve and secure with a cable tie.
Page 3B-78
b
c
32814
Description
a - Air compressor temperature sensor
b - Screw (M8 x 35)
c - Screws securing the air compressor cylinder head (4)
Where Used
Air compressor pulley screw threads
Nm lb‑in.
27
27
26410
Nm lb‑in.
19 170
90-8M0050731 MAY 2011
lb‑ft
20
20
lb‑ft
Part No.
92-809819