Powerhead
Oil Hoses and Reservoir Installation
1.
Install the oil reservoir onto the cylinder block. Secure the reservoir with three 0.312‑18 x 1.25 in. screws, washers, and two
clamps. Tighten the screws to the specified torque.
a
Description
Screw (0.312‑18 x 1.25 in.) (3)
NOTE: Attach the air compressor oil hose to the extended fitting on the oil pump.
2.
Install the oil hoses onto the oil pump and secure with cable ties.
d
3.
Install the oil pump onto the plenum. Secure the oil pump with three M8 x 30 screws, washers, and the 14 pin connector
mounting bracket. Tighten the screws to the specified torque.
b
a
Description
Screw (M8 x 30)
Page 4A-64
b
33954
e
a
c
d
a -
Screw and washer securing oil reservoir
b -
Screw and washer securing clamp and oil reservoir
a -
b
b -
c -
d -
e -
c
37189
a -
Bushing
b -
Grommet
c -
Bracket
d -
Washer
33780
Nm
lb‑in.
20
177
Oil hose for the air compressor
Oil delivery hose
Plenum
Oil pump
Extended fitting
Nm
lb‑in.
17
150
90-8M0050731 MAY 2011
lb‑ft
15
lb‑ft