Mercury 200 OptiMax Jet Drive Service Manual page 243

Direct Fuel Injection
Description
Nut securing air compressor
8. Tighten the two top screws (M10 x 25) securing the air compressor assembly to the cylinder block to the specified torque.
Description
Screw (M10 x 25) (2)
9. Secure the air compressor hose to the air compressor with a J‑clamp and cable tie. Secure the water hose and air compressor
hose to the air compressor with a cable tie.
a
b
10. Install two O‑rings onto the fuel rail air compressor hose fitting. Lubricate the O‑rings with 2‑cycle Premium Outboard Oil.
11. Install the fitting into the fuel rail and secure with a retainer and two screws. Tighten the screws to the specified torque.
a
Tube Ref No.
2-cycle Premium
14
Outboard Oil
Description
Screw
12. Secure the water inlet hose to the air compressor with a cable tie.
Page 3B-80
First
Final
c
c
c
b
32810
Description
O-rings on the fuel rail air compressor hose fitting
d
45930
a - Retainer
b - Screw (2)
c - Air compressor hose
Where Used
Nm lb‑in.
34
Nm lb‑in.
1.5 13
56
a - Water hose
b - Air compressor to fuel rail hose
c - Cable tie
d - Plastic J‑clamp
Part No.
92-858021K01
Nm lb‑in.
8 71
90-8M0050731 MAY 2011
lb‑ft
25
lb‑ft
41.3
lb‑ft