Starter System; Starter Removal And Installation - Mercury 200 OptiMax Jet Drive Service Manual

Tube Ref No.
2-4-C with Teflon
95
6. Install the belt tensioner assembly onto the stud and spring. Retain the belt tensioner assembly with a washer and nut.
7. Use a breaker bar to compress the belt tensioner spring. Verify the belt tensioner assembly stop is clear of the cylinder block
stop. Tighten the nut to the specified torque.
a
Description
Nut (M10)
8. Lubricate the belt tensioner assembly with 2‑4‑C with Teflon through the grease fitting.
Tube Ref No.
2-4-C with Teflon
95

Starter System

Starter Removal and Installation

Starter Removal
Performing service or maintenance without first disconnecting the battery can cause product damage, personal injury, or death
due to fire, explosion, electrical shock, or unexpected engine starting. Always disconnect the battery cables from the battery
before maintaining, servicing, installing, or removing engine or drive components.
1. Disconnect the battery cables from the battery.
2. Disconnect the wires from the starter solenoid.
90-8M0050731 MAY 2011
Description
a -
b -
b
32084
Description
!
Where Used
Belt tensioner
Cylinder block stop
Belt tensioner stop
Where Used
Belt tensioner
WARNING
Charging and Starting System
Part No.
92-802859A 1
Nm lb‑in.
20 180
Part No.
92-802859A 1
Page 2B-23
lb‑ft
15