Installation; Installing The Throttle Cable - Mercury 200 OptiMax Jet Drive Service Manual

2. Remove the cover by lifting off from the back of the engine.

Installation

1. Lower the cover opening onto the air plenum intake flange. Tilt the cover side to side until the cover slides down onto the
intake flange.
2. Push the cover down onto the alignment pins and onto the air intake tube for the air compressor.
a
3. Attach the retaining strap to the cover.

Installing the Throttle Cable

1. Shift the remote control into the neutral position.
90-8M0050731 MAY 2011
a
a - Flywheel cover
b - Retaining strap
b
44578
a -
b -
b
44545
a
a - Retaining strap
44528
Air plenum intake flange
Air intake tube for the air compressor
Jet Installation
Page 1D-17