Electrical Plate And Harness Removal - Mercury 200 OptiMax Jet Drive Service Manual

Powerhead
10. Remove three mounting bolts and remove the separator.
c
b
a
c
a - Fuel lift pump inlet hose
b - VST vent hose
c - Mounting bolts (M8 x 35) (3) (hidden)
d - Ground lead
e - High‑pressure fuel outlet hose
f - Low‑pressure fuel return hose
g - VST fuel inlet hose

Electrical Plate and Harness Removal

1. Remove the electrical plate cover.
2. Disconnect the temperature sensor connectors.
3. Remove the spark plug boots from the spark plugs.
4. Disconnect the fuel injector connectors.
5. Disconnect the direct injector connectors on the starboard fuel rail.
6. Disconnect the wiring harness retainers.
c
g
d
g
Page 4A-24
d
c
g
e
f
a -
b -
c -
a
d -
b
e -
f -
g -
e
45543
90-8M0050731 MAY 2011
e
f
g
45542
Screw and bushing
Electrical plate cover
Temperature sensor
connectors (2)
Direct injector connectors
(6)
Fuel injector connectors
(6)
Spark plug boots (6)
Wiring harness retainers
(4)