Table of Contents
Advertisement
Emulation
When the 7700 microprocessor is in the stop or wait mode, emulation
commands which access memory or registers will fail. You need to
Commands in
break the emulator into the monitor to use these commands. Once you
Stop/Wait Mode
break the emulator into the monitor, the stop or wait mode will be
released.
Stack Address
In some versions of 7700 microprocessor, the stack can be located in
Bank FF. However, the HP 64146A/B 7700 Series emulator doesn't
support the feature. The stack must be located in Bank 0.
1-10 Introduction
Advertisement
Table of Contents
