Setting The Parameters For The Machine Specifications - Mitsubishi Electric M800VW Series Connection And Set Up Manual

Hide thumbs Also See for M800VW Series:

Table of Contents

M800VW/M80VW Series Connection and Setup Manual

23 Setting the Parameters and Date/Time

23.3 Setting the Parameters for the Machine Specifications

(1) On the Mainte screen, select [Mainte] and then [Psswd input]. Enter the machine parameter password in the setting area

and press the [INPUT] key.

 To enter the character "A", press the shift key and then "A" key. Do not press both keys at the same time.

(2) Go back to the Mainte screen. Then select [Param].

Set the parameters according to the machine specifications. Setting of the following parameters is necessary.

[Base system parameters]

"#1025 I_plane" (Initial plane selection)

"#1026 base_I x" (Initial plane selection)

"#1027 base_J" (Base axis J)

"#1028 base_K" (Base axis K)

"#1029 aux_I" (Flat axis I)

"#1030 aux_J" (Flat axisJ)

"#1031 aux_K" (Flat axis K)

[Base axis specification parameters]

"#1603 PLCdev_no (Axis device assignment No.)"

 Set this in one of the following cases:

- When the system has five or more part systems

- When the part system has nine or more axes

- When you want to change the assignment of axis device

Part system 1

Part system 2

 The device Nos corresponding to (1) to (32) differ depending on device type.

IB-1501612-C

Part system 3

Part system 4