Table of Contents
Advertisement
M800VW/M80VW Series Connection and Setup Manual
7 Connection of Control Unit
7.10 Connecting with Manual Pulse Generator
7.10.1 Handle Numbers
There are two types of the handle numbers assignment: automatic assignment and arbitrary assignment.
Automatic assignment
Set all the parameters from "#1395 H1_pno" (1st handle selection) to "#1397 H3_pno" (3rd handle selection) to "0000".
An example is shown below.
"AIO": Connector on control unit (two channels), "MPG": Connector on operation panel I/O unit (three channels)
Operation panel I/O unit
Used
Not used
Control unit
Operation panel I/O unit
RIO3
AIO
Note
(1) M80VW does not include AIO connector.
(2) The manual pulse generator connected to FCU8-EX544 is not subject to the automatic arbitrary assignment.
Arbitrary assignment
Assign the handle I/F arbitrary according to the setting values of the parameters "#1395 H1_pno (1st handle selection)" to
"#1397 H3_pno (3rd handle selection)".
The manual pulse generator connected to FCU8-EX544 also follows the above parameter setting.
Handle assignment
1st handle
Group (a) ch1
Group (b) ch1
MPG
RIO3
(5V/12V)
[ Group (b) ]
Manual Pulse Generator (ch1)
Manual Pulse Generator (ch2)
(5V)
2nd handle
Group (a) ch2
Group (a) ch3
Group (b) ch2
[ Group (a) ]
Manual Pulse Generator (ch1)
Manual Pulse Generator (ch2)
Manual Pulse Generator (ch3)
257
3rd handle
IB-1501612-C
Advertisement
Table of Contents
