Table of Contents
Advertisement
M800VW/M80VW Series Connection and Setup Manual
40 Data Backup and Restoration
The following two functions are available for the data backup and restoration: all backup function for files in batch and input/
output function for separate files.
The following devices are available in all backup and restoration.
HD (Hard disk (for Windows-based display unit only))
Memory card (Front-side SD card)
DS (Control unit-side SD card)
USB memory
The master data backup and restoration are used for backing up and restoring the initial state data set by MTB. The built-in
memory is used for the master data backup and restoration regardless of the selected device.
Files to be backed up/restored are as follows.
Screen display
SRAM.BIN
ALL.PRM (*1)
System data
ASSEMBLY.INF (*1)
NCMEMORY2.IMG (*2)
USERPLC.LAD
EIPCONFDATA.BIN
Ladder
PLCMSG_XXX.TXT (*3)
PLCUMSG_XXX.TXT (*3)
MCRMSG_XXX.TXT (*3)
Safety parameter
SAFEPARA.BIN
Safety ladder1
SAFEPLC1.LAD
Safety ladder2
SAFEPLC2.LAD
APLC data
APLC.BIN
Custom data
(*1) These data can be backed up only. It cannot be restored.
(*2) This data is not included in the master data.
(*3) "XXX" indicates the abbreviation for each language.
For the input/output function for separate files, refer to the "Instruction Manual".
IB-1501612-C
File name
-
Data type
SRAM data (binary files)
Programs, parameters, R registers, etc.
Parameters
System configuration
Machining program data of NC memory 2
User PLC program
EtherNet/IP configuration file
PLC message file for MTB
PLC message file for users
Macro alarm message file
Safety parameter (binary file)
Safety PLC program1
Safety PLC program2
C language module created by user
Custom screen data
(Custom screen modules, setting files (Config.ini/customdef.ini/
customload.txt) and PLC alarm messages)
616
Advertisement
Table of Contents
