Handy Terminal Connection System Drawing; Connecting With Control Unit - Mitsubishi Electric M800VW Series Connection And Set Up Manual

Hide thumbs Also See for M800VW Series:

Table of Contents

M800VW/M80VW Series Connection and Setup Manual

17 Connection of Handy Terminal

17.1 Handy Terminal Connection System Drawing

This chapter briefly explains how to connect the handy terminal to each unit and device.

17.1 Handy Terminal Connection System Drawing

Handy terminal

Handy terminal

(1) When the handle of handy terminal is used on M80VW, connect ENC connector of G430 cable to MPG connector of the

operation panel I/O unit.

Because the pin assignment of ENC connector of G430 is different from that of MPG connector of the operation panel I/O

unit, conversion is required. The conversion cable needs to be prepared by the MTB.

Connect the handy terminal to SIO connector and AIO connector (M800VW only) of the control unit.

Also, connect the emergency stop switch (SW1), enable switch (SW2), selector switch (SW) and 24 VDC input to the control

panel terminal block.

Example connection of M800VW

Control unit

Control panel

terminal block

IB-1501612-C

Control unit

Control unit

Connector name: HOST

Handy terminal