Remote I/O Unit Connection System Drawing - Mitsubishi Electric M800VW Series Connection And Set Up Manual

M800VW/M80VW Series Connection and Setup Manual
11 Connection of Remote I/O Unit

11.1 Remote I/O Unit Connection System Drawing

This chapter describes the connection of the remote I/O unit and machine control signals.
11.1 Remote I/O Unit Connection System Drawing
Remote I/O unit
J070/J071 cable (*)
DCIN
J210 cable (*)
RIO1
J210 cable (*)
RIO2
J350/J351 cable
CJ31/CJ33
J350/J351 cable
CJ32/CJ34
CJ35
CJ36
SDI
SDI1/SDI2
SDO
SDO1/SDO2
J221 cable (*)
AIO1
THERMISTOR
AI
Note
(1) The mounted connector differs depending on the unit. Refer to the following chapter for which of the connector is
mounted.
"4.10 Remote I/O Unit"
(2) For connection to the machine operation panel, refer to the chapter "16 Connection of Machine Operation Panel".
(3) The section indicated with asterisk (*) indicates cable to be wired outside the electric cabinet.
Since the cable could be affected by the exogenous noise depending on the environment, the following noise counter-
measure is recommended.
Expose the cable by removing a part of the cable sheath and use the shield clamp for the exogenous noise countermeasure.
Shield
When you cannot use the shield clamp, install a ferrite core as a substitute.
<Related item>
Shield clamp fitting: "44.6.1 Shield Clamp Fitting"
Ferrite core: "44.6.2 Ferrite Core"
IB-1501612-C
24VDC Stabilized
power supply
Previous stage's remote I/O
Remote I/O unit,
Control unit,
etc.
Next stage's remote I/O or terminator
Remote I/O unit,
Operation panel I/O unit,
etc.
Machine control panel,
etc.
Machine control panel,
etc.
Machine control panel,
etc.
Machine control panel,
etc.
Machine control panel,
etc.
Machine control panel,
etc.
Analog I/O
(*)
Thermistor
(*)
Multi-analog input
Cable
296