Table of Contents
Advertisement
Details described in this manual
This book is configured as follows. Refer to the following chapters as necessary.
- Installation and connection: Chapter 1 to 18
- Setup: Chapter 19 to 39
In this manual, the following abbreviations might be used.
L system: Lathe system
M system: Machining center system
The numerical control unit is configured of the control unit, display unit, personal computer unit, operation board (operation
panel I/O unit), servo drive unit, spindle drive unit, power supply unit with driver, servomotor, spindle motor, etc.
In this manual, the following items are generically called "controller".
- Control unit
- Display unit
- Personal computer unit
- Operation board (operation panel I/O unit)
- Numerical control unit peripheral devices (input/output unit, safety unit)
In this manual, the following items are generically called "drive unit".
- Servo drive unit
- Spindle drive unit
- Power supply unit with driver
In this manual, the following items are generically called "motor".
- Servo motor
- Spindle motor
Advertisement
Table of Contents
