Table of Contents
Advertisement
M800VW/M80VW Series Connection and Setup Manual
14 Connection of Manual Pulse Generator
14.1 Manual Pulse Generator Connection System Drawing
The method for connecting to each unit and device from the manual pulse generator is briefly explained in this chapter.
14.1 Manual Pulse Generator Connection System Drawing
Connecting to control unit (5V)
5V manual pulse generator
J026/J027
Connecting to operation panel I/O unit (12V)
12V manual pulse generator
J020/J021/J022
Connecting to operation panel I/O unit (5V)
5V manual pulse generator
J023/J024/J025
Connecting to Encoder (manual pulse generator) I/F expansion unit (5V)
5V manual pulse generator
J026/J027
Note
(1) (*1) in the figure indicates cable to be wired outside the electric cabinet, and (*2) indicates cables to be wired outside the
operation panel.
Since the cable could be affected by the exogenous noise depending on the environment, the following noise counter-
measure is recommended.
Expose the cable by removing a part of the cable sheath and use the shield clamp for the exogenous noise countermeasure.
Shield
When you cannot use the shield clamp, install a ferrite core as a substitute.
<Related item>
Shield clamp fitting: "44.6.1 Shield Clamp Fitting"
Ferrite core: "44.6.2 Ferrite Core"
IB-1501612-C
cable
(*1)
AIO
Operation panel I/O unit
cable
(*2)
MPG
Operation panel I/O unit
cable
(*2)
MPG
Encoder (manual pulse generator) I/F
expansion unit
cable
(*1)
MPG
Cable
342
Control unit
Advertisement
Table of Contents
