Table of Contents
Advertisement
M800VW/M80VW Series Connection and Setup Manual
4 General Specifications
4.7 Personal Computer Unit
Connector
(15)
(3)
(14)
(4)
No. Connector name
(1) LVDS1
Display unit signal I/F 1st ch
(2) LVDS2
Display unit signal I/F 2nd ch
(3) INV
LED backlight connection
(4) MENUKEY
Menu key I/F
(5) USB2-1
USB 2.0 I/F 1st ch
(6) USB2-2
USB 2.0 I/F 2nd ch
(7) USB2-3
USB 2.0 I/F 3rd ch
(8) USB2-4
USB 2.0 I/F 4th ch
(9) USB2-5
USB 2.0 I/F 5th ch
CAUTION
Do not apply any voltage to the connectors other than voltage specified in this manual. Failure to observe this
could cause bursting, damage, etc.
Incorrect connections could cause the devices to rupture or damage, etc. Always connect the cables to the
indicated connectors or terminals.
Output from 12 V/5 V/3.3 V connectors is for powering peripheral devices only. If used for powering other
equipment, NC operation will not be guaranteed due to voltage drops or wraparound noise.
(1) LVDS1 (Display unit signal output 1st ch)
(2) LVDS2 (Display unit signal output 2nd ch)
(3) INV (LED backlight connection)
(4) MENUKEY (Menu key interface)
(2)
(1)
(13)
(18)
Function
65
(16)
(17)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
No. Connector name
(10) USB2-6
USB 2.0 I/F 6th ch
(11) USB3-1
USB 3.0 I/F 1st ch
(12) USB3-2
USB 3.0 I/F 2nd ch
(13) ON/OFF
Power supply ON/OFF I/F
(14) DCIN
24 VDC input
(15) CFAST
Built-in disk connection of display unit
(16) LAN
Ethernet I/F
(17) GDI
Ethernet I/F for control unit connection
(18) KEYUSB
Operation panel I/O unit connection
Function
IB-1501612-C
Advertisement
Table of Contents
