Laser I/F Unit Connection System Drawing - Mitsubishi Electric M800VW Series Connection And Set Up Manual

Hide thumbs Also See for M800VW Series:

Table of Contents

M800VW/M80VW Series Connection and Setup Manual

12 Connection of Laser I/F Unit

12.1 Laser I/F Unit Connection System Drawing

This chapter describes the connection of the laser I/F unit and machine control signals.

12.1 Laser I/F Unit Connection System Drawing

Laser I/F unit

(1) The section indicated with asterisk (*) indicates cable to be wired outside the electric cabinet.

Since the cable could be affected by the exogenous noise depending on the environment, the following noise counter-

measure is recommended.

Expose the cable by removing a part of the cable sheath and use the shield clamp for the exogenous noise countermeasure.

When you cannot use the shield clamp, install a ferrite core as a substitute.

Shield clamp fitting: "44.6.1 Shield Clamp Fitting"

Ferrite core: "44.6.2 Ferrite Core"

IB-1501612-C

24VDC Stabilized

power supply

24VDC Stabilized

power supply

Control unit

Laser oscillator