M800VW/M80VW Series Connection and Setup Manual
30 Setting the Backlash Compensation
30.1 Backlash Compensation
30.1 Backlash Compensation
Travel amount of a machine table may become less than the commanded amount due to the error (backlash) caused by
reversal of the direction of the axis.
The backlash compensation is a function which automatically adds compensation amount to the travel amount when the
direction of the axis is reversed.
+
Machine table
There are two types of backlash compensation as follows.
G0 backlash (#2011 G0back)
Compensation amount that is used when an axis moved at the rapid traverse speed (G0).
Compensation amount is also measured at rapid traverse speed.
G1 backlash (#2012 G1back)
Compensation amount that is used when an axis moved at cutting feedrate (G1, G2, G3).
Compensation amount to be set is measured using the most commonly used feedrate.
IB-1501612-C
-
Ball screw
(Motor)
Backlash
534