Table of Contents
Advertisement
M800VW/M80VW Series Connection and Setup Manual
25 Confirming the Basic Operation
25.3 Servo Simplified Adjustment
25.3.2 NC Analyzer2
Servo parameters can be automatically adjusted by measuring and analyzing the machine characteristics. Measurement and
analysis are conducted by driving the motor using machining programs for adjustment or vibration signals. Various data can
also be sampled.
Control unit
NC Analyzer2
[Functions]
Adjustment wizard
Velocity loop gain adjustment
Lost motion adjustment
Measurement and adjustment
Frequency response measurement Measures the frequency response of speed loop for the designated axis. The result will be output as fre-
Reciprocation acceleration/deceler-
ation measurement
Roundness measurement
Synch tap error measurement
Spindle acceleration/deceleration
measurement
Spindle orientation measurement
Spindle C-axis measurement
Spindle synchronization measure-
ment
PLC axis acceleration/deceleration
measurement
Arbitrary path measurement (*2)
(*1) For the measurement, use a machining program created by the program creation function of NC Analyzer2 or any
machining program.
(*2) Two or more NC axes in the same system are needed.
For details, refer to "NC Analyzer2 Instruction Manual".
Drive unit
Automatically adjusts velocity loop gain and resonance filters.
Adjusts the lost motion automatically for the delay in response caused when the direction of the machine
rotates is reversed.
quency response waveform.
Measures the reciprocation acceleration/deceleration for the designated axis. The result will be output as
time-series waveform. (*1)
Measures the roundness for the designated axis. The result will be output as roundness waveform. (*1)
Measures the synchronous tap error for the designated axis. The result will be output as time-series
waveform. (*1)
Measures the spindle acceleration/deceleration for the designated axis. The result will be output as time-
series waveform. (*1)
Measures the spindle orientation for the designated axis. The result will be output as time-series wave-
form. (*1)
Executes the reciprocation acceleration/deceleration measurement of spindle C axis with specified axis.
The result will be output as time-series waveform. (*1)
Executes an arbitrary machining program with specified axis, and measures spindle synchronization by
using that data. The result will be output as time-series waveform.
Executes an arbitrary machining program with specified axis, and measures PLC axis acceleration/de-
celeration by using that data. The result will be output as time-series waveform.
Executes an arbitrary machining program with specified two axes. The result will be output as arbitrary
path measurement waveform. (*1)
473
Description
Description
IB-1501612-C
Advertisement
Table of Contents
