Mitsubishi Electric M800VW Series Connection And Set Up Manual page 497

Hide thumbs Also See for M800VW Series:

Table of Contents

M800VW/M80VW Series Connection and Setup Manual

24 Sequence Program Writing

24.6 Writing a Sequence Program with GX Works2

 If an attempt is made to remove the check from parameter and write sequence programs while a PLC is running, the

message shown below is displayed.

"Your PC is running. Force the file to be written?"

The CNC only supports writing during RUN from the [Compile] menu; if [Yes] is clicked, an error dialog is displayed and

sequence programs are not written.

Click [No] and then click [Yes] when the following message is displayed:

"Perform a remote stop and write to PC?"

IB-1501612-C