Powering Down The Sx-200 Light Control Node; Powering Down The Peripheral Nodes; Powering Down The Ip Node - Mitel SX-200 EL Technician's Handbook

Technician's Handbook

Powering Down the SX-200 LIGHT Control Node

1. End any customer data entry sessions.
2. If you don't have an up-to-date database backup, perform a
database backup.
Refer to Backing Up a Customer Database (page 27).
3. Push the System Reset Button.
4. Remove the disks.
5. Turn off the AC power by pushing the 0 (off) button at the rear of the
cabinet. Disconnect the power cords from the AC power source.

Powering Down the Peripheral Nodes

1. Set the Bay Power Supply switch to O (OFF).
2. Unplug the AC power cord from the rear of the node.

Powering Down the IP Node

Unplug the AC power cord from the rear of the node.
58