Error Messages - Mitel SX-200 EL Technician's Handbook

Technician's Handbook

Error Messages

Table 15: SX-200 IP Node Troubleshooting Table
Indication
WARNING: SX200
Main control not
connected or IP Node
not supported
94
Possible Causes
Defective Ethernet
cables
The Control Triple CIM
card is programmed as
a Dual CIM card.
The CIM cable is
connected to the
wrong port on the
SX-200 IP Node
The IP Bay is not
programmed in CDE
Form 01
Programming in CDE
Form 04 and CDE
Form 47 is not correct
Action
Replace the Ethernet
Crossover cable and
CIM cable.
Reprogram the Triple
CIM Card.
Check the hardware
connections.
Program the IP Bay in
CDE Form 01.
Check the
programming in CDE
Form 04 and CDE
Form 47.
(Sheet 1 of 2)