Test Line - Mitel SX-200 EL Technician's Handbook

Technician's Handbook

Test Line

The test line is on the ONS line card at Bay 1, Slot 1, Circuit 1 for the
SX-200 EL/ML or Bay 2, Slot 1, Circuit 1 for the SX-200 LIGHT/
DIGITAL. An access code for Feature 18, Maintenance Function - Test
Line, must first be programmed in CDE Form 02 (Feature Access
Codes).
Refer to Table 22, "Feature Access Codes," on page 136.
The test line cannot be accessed while CDE or maintenance is
active.
Specifying Equipment From Test Line
Circuits are specified using their physical location numbers (bay, slot,
circuit, subcircuit) or by Link and Channel number.
A receiver circuit at location Bay 1, Slot 3, Circuit 3, Subcircuit 4 is
specified as "01 03 03 04".
A line circuit at location Bay 1, Slot 1, Circuit 6 is specified as "01 01 06
00". Circuits with no subcircuit number (such as lines and trunks) must
be specified with "00" as the subcircuit.
Channels are specified by using the required Link number and Channel
number. The link number is a two-digit number (Links 0, 1, 14, or 15
cannot be tested). The Channel number is a two-digit number from 00
to 31. Channel 30 on Link 9 is specified as "09 30".
Commands are entered on the test line by dialing command codes
listed in Table 16 using the DTMF keypad or the rotary dial of the set
being used.
96