Mitel SX-200 EL Technician's Handbook page 47

7. Choose a location for the installSetup program to install files
(normally this is C:\intpub\ftproot). The installSetup program
provides a progress indicator and a log file.
8. Click Finish when prompted.
You are presented with a text file providing instructions.
9. Launch the communications program that connects to the SX-200
IP Node Maintenance port.
10. Enter "reboot" to reboot the SX-200 IP Node.
11. Press a key at the "Press any key to stop auto-boot" prompt to stop
the auto-boot.
12. At [VxWorks Boot] type "c" and then press Enter.
13. Change the following parameters as indicated:
- Boot device : motfcc
- File name : Boot_Install
- Host inet : <the IP address of the ftp server PC host (your PC)>
- User (u) : <user name for FTP server in PC host>
- Ftp password (pw) (blank = use rsh) : <password for FTP server in
PC host>
- Flags (f) : 0x0 (this is the default setting and should not have to be
changed).
14. Press the reset button on the SX-200 IP Node, or at the PC, enter
"@" to reboot the SX-200 IP Node.
The software installation takes about 10 minutes. The SX-200 IP
Node reboots two times.
Routine Maintenance
37