Mitel SX-200 EL Technician's Handbook page 102

Technician's Handbook
Table 14: Floppy Disk Drive Error Code Summary
Error
Code
E. Original system diskette has been replaced, and logs are pending.
1 Either re-insert original diskette, or restart system. See Note 2.
E. Original system diskette has been replaced. Either re-insert original
2 diskette, or restart system. See Note 2.
E. Disk drive is empty, and disk updates are pending. Either re-insert
3 original diskette, or restart system. Disks may be locked (try
backups). See Note 2.
E. Disk drive is empty. Either re-insert original diskette, or restart
4 system. See Note 2.
E. There is an obstruction over the diskette "write notch" (a
5 write-protect sticker) - remove it, or on a 31/2" disk, slide protector
over the hole.
E. Diskettes A and B don't match (are not of the same load) - insert
6 proper diskettes and restart system.
E. Restart system. If this persists, assume faulty Main Control - refer to
7 the Main Control procedures.
E. Decryption Module is missing - install correct module, and restart
8 system. If this persists, assume faulty Main Control - refer to the
Main Control procedures.
E. Information cannot be accessed on disks. Either re-insert
F diskette, or restart system.
NOTE: 1. Be aware of the difference between the code "E" and the code "E.". "E" indi-
cates MCC error and "E." indicates disk drive errors.
2. If system is restarted at this point, the pending logs will be lost.
92
Likely Cause(s)