Physical Description; General; Body; Base Assembly - Mitel SX-200 Manual

3. PHYSICAL DESCRIPTION

General

Body

Base
Cover
Volume
3.01 The SUPERSET 4 telephone body and handset are of plastic
construction. The dimensions of the SUPERSET
with handset on-hook, are given in Figure 3-l.
3.02 The body and handset are connected together with a modular
detachable handset cord, plugged into the side of the body. Line
connection to the set is by means of a modular detachable line cord,
plugged into the rear of the set.
3.03 An optional rear support can be clipped in position beneath the
set. This would be used when the set is likely to be placed
some distance from the user (Figure 3-3).
3.04 The body of the SUPERSET
base assembly and a cover assembly (Figure 3-2).
Assembly
3.05 The base assembly contains a microphone (for handsfree op-
eration), modular jacks for the handset and line cords, the main
circuit card, and a speaker assembly (for handsfree operati.on
ringer output). The microphone is mounted in a position which permits
it to receive sound passing through an aperture in the front of the

base assembly.

3.06 A screwdriver slotted control for adjusting ringer pitch is user-
accessible from the underside of the base assembly.
Assembly
3.07 The cover assembly houses a volume control assembly, a key-
pad module, and a line selection/repertory dial module. The
speaker is located between the handset recesses, and projects sound
upwards through a grill beneath the handset.
Control Assembly
3.08 Two volume controls, one each for speaker and ringer, are
mounted in the upper left-hand corner of the cover assembly.
The controls are edge-mounted and are identified with a printed card
insert. This card also has space .for the installed telephone number,
and 'is held in place by a transparent plastic lens that is clipped in
position.
4 Telephone information
4 telephone comprises two parts: a
4 telephone,
and tone
Page 5