Programming An Attendant Console - Mitel SX-200 EL Technician's Handbook

Programming an Attendant Console

1. Form 01, System Configuration
Program a Digital Line Card (assigned as a high-power card in
n
the SX-200 LIGHT) or a DNIC module for a DNIC Console. Use
the first port on the Digital Line Card for the console.
or
Program a Console Module on a Universal Card for an LCD
n
Console.
2. Form 07, Console Assignment
Assign an extension number, COS, COR, and Tenant for each
n
console bay/slot/circuit entry.
3. Form 08, Console LDN Assignment
Assign a directory number and label to each required console
n
LDN key.
Console Descriptions
SUPERCONSOLE 1000
connection to connect to one circuit on a Digital Line Card or DNIC
Module (Tip to Tip and Ring to Ring). With LIGHTWARE 18 or
greater, the SUPERCONSOLE 1000, PN 9189-000-300 and
9189-000-301 can directly connect up to two PKM48 devices; these
consoles with software prior to LIGHTWARE 18 and the
SUPERCONSOLE 1000, PN 9189-000-001-NA and 9189-000-003
NA require a DSS/BLF Interface Unit to associate with the PKM48.
SUPERSET 7000 Attendant Console: includes a RS-232 port and
requires a 2-wire connection to a DNIC port. This console requires
a DSS/BLF Interface Unit in order to associate with a PKM48.
LCD Console: does not include a RS-232 port and requires a
4-wire connection to a console module. The SX-200 EL
LIGHTWARE 17 Release 1.1, 2.0, and 3.0 do not support the LCD
console; Release 3.1 and greater does.
®
Attendant Console: uses a two-wire
Programming
103