Peripheral Interface Cabling
Use the tables in this section to connect backplane connectors to the
main distribution frame.
USOC Pin Designations
The USOC connector numbers are
RJ21X for CO trunks
n
RJ2EX for 2-wire E&M trunks
n
RJ2FX for 4-wire E&M trunks
n
RJ2GX for 4-wire E&M trunks
n
RJ2HX for 4-wire E&M trunks.
n
SX-200 EL/ML Peripheral Interface Card Slot
Assignments
With LIGHTWARE 17 and greater, the SX-200 EL/ML cabinets do not
have high power and low power designations. Slots 1 to 8 can accept
any peripheral interface card, except T1 trunk. A maximum of four
high-power cards are allowed (there are no high-power or low-power
slots). Beginning at slot 1, the system accepts the first four high power
cards it detects. The high-power cards are DID, Universal, COV, and
T1. T1 Trunk cards can be installed in slots 10 and 11 only, but they
require slots 5 and 6 respectively to be left empty. Software recognizes
slots 5 and 6 as being occupied and the T1 cards are counted as high
power cards in slots 5 and 6.
Installation
197