Ip Node - Mitel SX-200 EL Technician's Handbook

Technician's Handbook
SX-200 IP Node
You can connect up to two SX-200 IP Nodes to the SX-200 EL. The
system requires one Control Triple CIM card (three onboard CIM
circuits) in the main control cabinet and one Bay Control Card III.
The following connections are required to configure the SX-200 IP
Node:
Connections between peripheral bays and the main control cabinet
n
are made with standard CIM connections.
An Ethernet crossover cable connects the Control Triple CIM Card
n
in the main control cabinet to CIM port 4 on the IP Node. All voice
communications are carried over this connection.
A standard Ethernet cable connects the Bay Control Card III to the
n
Local Area Network (LAN). This connection carries the signaling
information.
Another Ethernet crossover cable connects the IP Node to the
n
Ethernet switch on the LAN.
The IP phones are connected to the LAN through the Ethernet
n
switch.
14