Control Triple Cim Card Switch Settings - Mitel SX-200 EL Technician's Handbook

Technician's Handbook
Control Triple CIM Card
Switch Settings
The S1 switch (switch 4) on the Control Triple CIM card determines
whether the card provides a double interface or a triple interface.
The S1 switch (switch 1, 2, or 3) substitutes one of the CIM circuits for
a fiber circuit.
If the Control Triple CIM card is to provide a triple interface (emulate a
control triple carrier card with 9 links), verify that switch 4 on the S1
switch is in the closed position (the default).
If the Control Triple CIM card is to provide a double interface (emulate
a control dual carrier card with 6 links), set switch 4 to the open position.
If a FIM II is installed on the Control Triple CIM card, set the S1 switch
to assign a circuit to the FIM II. Closing switch 1, 2, or 3 replaces the
CIM circuit 1, 2, or 3 respectively. Close only one of these switches. The
FIM II takes on the configuration rules of the CIM circuit that is replaces.
For example, a FIM II replacing CIM circuit #1 (in slot 10) connects to
the FIM or FIM II in Bay 2. A FIM II replacing CIM circuit #1 (in slot 11)
connects to the FIM or FIM II in Bay 4.
196