Programming A Class Trunk - Mitel SX-200 EL Technician's Handbook

Technician's Handbook

Programming a CLASS Trunk

Programming a LS/CLASS Trunk card requires
LIGHTWARE 19 Release 2.0 or greater software.
1. Form 01, System Configuration
Program the LS/CLASS Trunk module or the LS/CLASS Trunk card.
n
2. Form 03, Class of Service, Define for trunks.
Assign a separate COS for the trunk.
To have Calling Line ID digits reported in the SMDR records, enable
n
COS Option 806 (SMDR-Record Incoming Calls) and COS Option
814 (SMDR-Record ANI/DNIS/CLASS). Enable COS Option 702
(SMDR - Overwrite Buffer).
To have CLASS name reported in the SMDR records, enable COS
n
Option 246 (SMDR-Extended Record) and COS Option 814
(SMDR-Record ANI/DNIS/CLASS).
3. Form 03, Class of Service, Define for SUPERSET sets.
To display Calling Line ID digits on a SUPERSET display set or
n
console, enable COS Option 502 (Display ANI/DNIS/CLASS
Information) in the class of service for the set/console. Enable COS
Option 613 - Display ANI Information Only if required.
To display CLASS name before Calling Line ID digits on a
n
SUPERSET small display set (SUPERSET 4025, SUPERSET
4125, or SUPERSET 420 telephones), enable COS Option 503
(Display CLASS Name) in the class of service for the set.
4. Form 13, Trunk Circuit Descriptor
Assign the CLASS trunk with the circuit descriptor. An LS/CLASS
n
Trunk module uses "4-CIRCUIT CLASS ". An LS/CLASS Trunk card
uses "8-CIRCUIT CLASS"
126