System Log Messages; Table 1: Firmware Commands - Mitel SX-200 EL Technician's Handbook

Technician's Handbook
Set_Firmware
Qualifiers
STATUS
DOWNLOAD
ABORT_DOWNLOAD
FORCE_DOWNLOAD

System Log Messages

If a firmware download fails, the reason for the failure will be reported in
the system logs. If a failure occurs, the download will be aborted and the
remaining sets on the list will not receive the download.
The conditions and restrictions that apply to the firmware
download are described in Upgrading Set Firmware in the
Maintain section of the SX-200 EL/ML Technical Documentation.
34

Table 1: Firmware Commands

Displays the software revision level the
set is running and whether the set is
scheduled for a download.
Erases and updates the firmware on all
specified sets. The set must be idle and
the set's firmware revision must be older
than the firmware to be downloaded.
Removes specified sets from the sched-
uled download.
Forces the download to occur even if the
set firmware is newer than the firmware
being downloaded. This command allows
a set's firmware to be returned to a
previous firmware version when required.
Result