Technician's Handbook
Upgrading by Replacing Flash Memory
You can upgrade SX-200 IP Node software by replacing the flash
memory card in the SX-200 IP Node.
To replace the flash memory card
1. Disconnect all cables from the SX-200 IP Node.
2. Turn the SX-200 IP Node upside down.
3. Remove the six screws on the removable panel, as indicated in the
figure below.
Do not remove the four screws indicated in the figure. If you
remove the four screws, components will fall into the interior
of the box.
Figure 10: Removing the bottom panel
38