Programming An Analog Device To A Sim2; Programming A Multi-Line Set - Mitel SX-200 EL Technician's Handbook

Programming an Analog Device
to a SIM2
The analog interface in the SIM2 supports devices such as analog
telephones, fax machines, or modems. The SUPERSET provides the
power to the analog interface.
Ensure that the set firmware revision level meets the system firmware
revision level. If the revision level on the system is higher than the set
revision level, upgrade the set firmware.
Refer to Upgrading Set Firmware (page 33).
When adding an analog set to a SIM2, use CDE Form 12 to program
the port. The port type is AIM.

Programming a Multi-Line Set

1. Form 01, System Configuration
Program a Digital Line Card, DNIC module, or COV line card.
n
LIGHTWARE 16 for the SX-200 ML and LIGHTWARE 17 and
greater for the SX-200 EL/ML do not support SUPERSET 3 or
SUPERSET 4 sets (COV). COVs are reserved for voice mail
only.
2. Form 09, Desktop Device Assignments
Assign set type, extension number, COS, COR, and name
n
(optional) for each bay/slot/circuit.
Set types are SUPERSET 4001, 4015, 4025, 4125, 4090, 4150,
n
401+, 410, 420, 430, 4150 S/Att, 430 S/Att, 3DN, and 4DN.
Complete the Form 09 sub-form for key types and options.
n
Programming
109