Disk Drive Strapping; Troubleshooting The Sx-200 Ip Node - Mitel SX-200 EL Technician's Handbook

Disk Drive Strapping

When replacing a floppy disk drive on an SX-200 LIGHT PBX, verify
that the switch settings for the drives are set as follows:
Drive A: AT DC MO D0
n
Drive B: AT DC MO D1
n
When replacing a floppy disk drive on an SX-200 DIGITAL PBX, verify
that the switch settings for the drives that are mounted on a floppy disk
mounting card are set as follows:
Drive A: AT DC MO D0
n
Drive B: AT DC MO D0
n
On an ISDN Node, verify that the switch settings for the drive are:
Drive A: AT DC MO D1
n

Troubleshooting the SX-200 IP Node

To observe error messages from the SX-200 IP Node
1. Using a serial cable, connect a PC to the Maintenance Port on the
IP Node.
2. Launch a data communication application, such as Hyperterminal
on the PC.
3. Set the parameters: 9600, 8, N, 1, None.
4. Look for error messages in the SX-200 IP Node Troubleshooting
Table on page 94.
Troubleshooting and Repair
93