NetApp StorageGRID SG6000 Manual page 97

Bonding mode:
MAC Addresses:
Client Network:
Bonding mode:
VLAN:
MAC Addresses:
Grid Network
CIDR:
MAC:
Gateway:
Subnets:
MTU:
Admin Network
CIDR:
MAC:
Gateway:
Subnets:
MTU:
Client Network
CIDR:
MAC:
Gateway:
MTU:
##############################################################
##### If you are satisfied with this configuration,
##### execute the script with the "install" sub-command. #####
##############################################################
4. If you need to change any of the values in the current configuration, use the
update them. For example, if you want to change the IP address that the appliance uses for connection to
the primary Admin Node to 172.16.2.99, enter the following:
configure-sga.py configure --admin-ip 172.16.2.99 SGA-INSTALL-IP
5. If you want to back up the appliance configuration to a JSON file, use the
subcommands. For example, if you want to back up the configuration of an appliance with IP address
to a file named appliance-SG1000.json, enter the following:
INSTALL-IP
configure-sga.py advanced --backup-file appliance-SG1000.json SGA-INSTALL-IP
The JSON file containing the configuration information is written to the same directory you executed the
no-bond
00:80:e5:29:70:f4
ENABLED
active-backup
novlan
00:a0:98:59:8e:89
172.16.2.30/21 (Static)
00:A0:98:59:8E:8A
172.16.0.1
172.17.0.0/21
172.18.0.0/21
192.168.0.0/21
1500
10.224.2.30/21 (Static)
00:80:E5:29:70:F4
10.224.0.1
10.0.0.0/8
172.19.0.0/16
172.21.0.0/16
1500
47.47.2.30/21 (Static)
00:A0:98:59:8E:89
47.47.0.1
2000
00:a0:98:59:8e:81
#####
subcommand to
configure
and
advanced backup-file
SGA-
95