NetApp StorageGRID SG6000 Manual page 133

If a bezel is installed on the controller, it might be difficult to see the front identify LED.
After you finish
To turn off the controller identify LED:
• Press the identify LED switch on the controller front panel.
• From the controller BMC interface, select Server Identify, select OFF and then select Perform Action.
The blue identify LEDs on the front and rear of the controller go off.
Related information
Verify Fibre Channel HBA to replace
Locate controller in data center
Access BMC interface
Locate controller in data center
Locate the controller so that you can perform hardware maintenance or upgrades.
What you'll need
• You have determined which controller requires maintenance.
(Optional) To help locate the controller in your data center, turn on the blue identify LED.
Turn controller identify LED on and off
Steps
1. Find the controller requiring maintenance in the data center.
◦ Look for a lit blue identify LED on the front or rear of the controller.
The front identify LED is behind the controller front bezel and might be difficult to see if the bezel is
installed.
131