NetApp StorageGRID SG6000 Manual page 163

3. When you are satisfied with the settings, select Save.
4. If this procedure completed successfully and you have additional procedures to perform while the node is
in maintenance mode, perform them now. When you are done, or if you experienced any failures and want
to start over, select Advanced > Reboot Controller, and then select one of these options:
◦ Select Reboot into StorageGRID
◦ Select Reboot into Maintenance Mode to reboot the controller with the node remaining in
maintenance mode. Select this option if you experienced any failures during the procedure and want to
start over. After the node finishes rebooting into maintenance mode, restart from the appropriate step in
the procedure that failed.
161