Deploy Appliance Storage Node - NetApp StorageGRID SG6000 Manual

5. For Original Port, enter the number of the port you want to remap.
6. For Mapped-To Port, enter the number of the port you want to use instead.
7. Click Add Rule.
The new port mapping is added to the table, and the remapping takes effect immediately.
8. To remove a port mapping, select the radio button for the rule you want to remove, and click Remove
Selected Rule.

Deploy appliance Storage Node

After installing and configuring the storage appliance, you can deploy it as a Storage
Node in a StorageGRID system. When you deploy an appliance as a Storage Node, you
use the StorageGRID Appliance Installer included on the appliance.
What you'll need
• If you are cloning an appliance node, continue following the process in recovery and maintenance.
Recover and maintain
• The appliance has been installed in a rack or cabinet, connected to your networks, and powered on.
• Network links, IP addresses, and port remapping (if necessary) have been configured for the appliance
using the StorageGRID Appliance Installer.
• You know one of the IP addresses assigned to the appliance's compute controller. You can use the IP
address for any attached StorageGRID network.
• The primary Admin Node for the StorageGRID system has been deployed.
• All Grid Network subnets listed on the IP Configuration page of the StorageGRID Appliance Installer have
been defined in the Grid Network Subnet List on the primary Admin Node.
• You have a service laptop with a supported web browser.
About this task
Each storage appliance functions as a single Storage Node. Any appliance can connect to the Grid Network,
the Admin Network, and the Client Network
84