NetApp StorageGRID SG6000 Manual page 28

Information needed
Admin Network enabled
Network bond mode
Switch port for the left port in the red circle in the
diagram (default active port for Independent network
bond mode)
Switch port for the right port in the red circle in the
diagram (Active-Backup network bond mode only)
MAC address for the Admin Network port
Note: The MAC address label on the front of the
SG6000-CN controller lists the MAC address for the
BMC management port. To determine the MAC
address for the Admin Network port, you must add 2
to the hexadecimal number on the label. For example,
if the MAC address on the label ends in 09, the MAC
address for the Admin Port would end in 0B. If the
MAC address on the label ends in (y)FF, the MAC
address for the Admin Port would end in (y+1)01. You
can easily make this calculation by opening Calculator
in Windows, setting it to Programmer mode, selecting
Hex, typing the MAC address, then typing + 2 =.
DHCP-assigned IP address for the Admin Network
port, if available after power on
Note: You can determine the DHCP-assigned IP
address by using the MAC address to look up the
assigned IP.
Static IP address you plan to use for the appliance
Storage Node on the Admin Network
Note: If your network does not have a gateway,
specify the same static IPv4 address for the gateway.
Admin Network subnets (CIDR)
26
Your value
Choose one:
• No
• Yes (default)
Choose one:
• Independent (default)
• Active-Backup
• IPv4 address (CIDR):
• Gateway:
• IPv4 address (CIDR):
• Gateway: