NetApp StorageGRID SG6000 Manual page 26

Callout
A
I
Gather installation information (SG6000)
As you install and configure the StorageGRID appliance, you must make decisions and
gather information about Ethernet switch ports, IP addresses, and port and network bond
modes.
About this task
You can use the following tables to record the required information for each network you connect to the
appliance. These values are required to install and configure the hardware.
Information needed to connect to SANtricity System Manager on storage controllers
You must connect both of the storage controllers in the appliance (either the E2800 controllers or the EF570
controllers) to the management network you will use for SANtricity System Manager. The controllers are
located in each appliance as follows:
• SG6060: Controller A is on the top, and controller B is on the bottom.
• SGF6024: Controller A is on the left, and controller B is on the right.
Information needed
Ethernet switch port you will
connect to management port 1
(labeled as P1 on the controller)
MAC address for management port
1 (printed on a label near port P1)
24
Network bond mode
Both management ports are bonded into one logical
management port connected to the Admin Network.
The port on the left is connected to the Admin
Network. The port on the right is available for
temporary local connections (IP address
169.254.0.1).
Your value for controller A Your value for controller B