NetApp StorageGRID SG6000 Manual page 30

Information needed
Static IP address you plan to use for the appliance
Storage Node on the Grid Network
Note: If your network does not have a gateway,
specify the same static IPv4 address for the gateway.
Grid Network subnets (CIDRs)
Information needed to connect SG6000-CN controller to Client Network
The Client Network for StorageGRID is an optional network, typically used to provide client protocol access to
the grid. The appliance connects to the Client Network using the 10/25-GbE ports on the SG6000-CN
controller.
Information needed
Client Network enabled
Network bond mode
VLAN tagging enabled
VLAN tag(If VLAN tagging is enabled)
DHCP-assigned IP address for the Client Network, if
available after power on
Static IP address you plan to use for the appliance
Storage Node on the Client Network
Note: If the Client Network is enabled, the default
route on the controller will use the gateway specified
here.
Information needed to connect SG6000-CN controller to BMC management network
You can access the BMC interface on the SG6000-CN controller using the following 1-GbE management port.
This port supports remote management of the controller hardware over Ethernet using the Intelligent Platform
28
Your value
• IPv4 address (CIDR):
• Gateway:
Your value
Choose one:
• No (default)
• Yes
Choose one:
• Active-Backup (default)
• LACP (802.3ad)
Choose one:
• No (default)
• Yes
Enter a value between 0 and 4095:
• IPv4 address (CIDR):
• Gateway:
• IPv4 address (CIDR):
• Gateway: